Step 1: Screw tip into shank until finger tight (Fig. 1a). Note a .010" gap (Fig. 1b).

Step 2: Use wrench to torque approximately 1/4 turn, creating a simultaneous fit (Fig. 2).
(continued below)

Fig. 1a

Fig. 1b

Fig. 2

Step 3: Use .001" ship stock to check the simultaneous fit at the intersection of the tip and the shank. The shim should not be able to enter the intersection (Fig. 3a).
If it does, tighten further with the wrench until there is no gap (Fig. 3b).

Note: Pre-set torque wrenches (Series NCH-200) can be purchased.

Fig. 3a

Fig. 3b