Series: RSJ
Representative image shown ⓘ
The image above is intended to represent the product series for illustrative purposes only. The actual product may vary.
Product Series Features:
- Pressed Single-Ended Insert
- For Parting & Grooving
- J-Type Chipbreaker
Part Number |
SSC Insert Seat Size |
CW Cutting Width |
RE Corner Radius |
WB Body Width |
INSL Insert Length |
FEEDGN Grooving Feed Min. |
FEEDGX Grooving Feed Max. |
|
|---|---|---|---|---|---|---|---|---|
| RSJ3 | 3 | 0.118 | 0.008 | 0.094 | 0.551 | 0.002 | 0.006 |
Part Number |
SSC Insert Seat Size |
CW Cutting Width |
RE Corner Radius |
WB Body Width |
INSL Insert Length |
FEEDGN Grooving Feed Min. |
FEEDGX Grooving Feed Max. |
|
|---|---|---|---|---|---|---|---|---|
| RSJ2 | 2 | 0.079 | 0.008 | 0.067 | 0.551 | 0.002 | 0.005 | |
| RSJ3 | 3 | 0.118 | 0.008 | 0.094 | 0.551 | 0.002 | 0.006 |
Parting and Grooving Chip Breakers
- 1st choice for general use in parting and deep grooving
- Stable cutting edge & interrupted cut
- Medium-to-high feed
- For carbon steel, alloy steel and cast iron
- For hard materials
- 1st choice for soft materials in parting and deep grooving
- Sharp cutting edge & low cutting force
- Low-to-medium feed
- Tubes, small diameter and thin-wall parts
- For stainless steel & low carbon steel
- For heat resistant super alloy
- Sharp cutting edge and wide groove with minimized burrs
- For tubes of small size workpieces
- For stainless steel and mild steel
- Narrow chip breaker
- Good chip control in low feed of ductile materials and low-carbon steel
- For Cr-Ni alloy steel and bearing steel
